Pages

Monday, January 23, 2012

Stitch and Glue Pram Dingy. A Weekend Project

Here is a project by Mark Corke, which would only take a couple of weekends to complete. It follows the traditional stitch and glue method  and below is a small extract of his project. The complete article  can be read at  his web site here
snip...
"A kit boat is good introduction to boat building, as little preparatory work is needed before construction commences. You will need some space and typically this will be the family garage but because the boat takes shape so quickly the car will not have to stay outside for more than few days.

The boat is built using what is often called the stitch and glue method, pioneered successfully many years ago by Barry Bucknell and Jack Holt in the mirror dinghy. Now however rather then using polyester resin and glass tape epoxy resin has taken over and is used both as glue and coating material.
 The average reader is likely to have more than enough tools and skill to successfully build this boat but I would strongly recommend building a couple of strong sturdy saw horses on which to work. Make sure that the work area floor is level because it is all too easy to build a twist into the boat. Read the through the instructions several times before you start is a piece of advice that I should have told myself in past construction projects. Reading the plans and instructions that come with any kit will make the project go that much easier.

I mostly followed the manufacturers instructions but where I deviated I did so as either time saving method of work or because experience has taught me that their might be a better way of doing it. Next issue I will be concentrating on painting and varnishing.

Building the Eastport pram took me about 40 hours of building time and this is a reasonable estimate but expect to put as much time in again on the finishing if you want a high quality job." continues.......





The whole project can be read at this link here

No comments:

Post a Comment

Note: Only a member of this blog may post a comment.